Henderson County Mine safety activity
MSHA violations, accident reports and inspections.
Safety activity
Electric equipment; examination, testing, and maintenance.
30 CFR 77.502 · $151.00 proposed penalty
Handling of materials
Days away from work only
Accident narrative
Employee was drilling a hole to install a pin when the steel became stuck. As they went to pull the steel out they felt a pain in their right shoulder. They continued to work their normal job until they were taken off work beginning 9/5/25 as they were unable to perform their normal job.
Handling of materials
Days away from work only
Accident narrative
Employee was lifting a man door for a brattice when they felt a sharp pain in lower back. They finished the shift, but when they awoke the next day, they were having lower back pain. EE was seen by a physician on 7/31/25 and was taken off work as they were unable to perform their normal job.
Preshift examination at fixed intervals.
30 CFR 75.360(g) · $151.00 proposed penalty
Criteria—Belt conveyors.
30 CFR 75.1403-5(g) · $151.00 proposed penalty
Powered haulage
No dys awy frm wrk,no rstr act
Accident narrative
Employee was using a lo trac to compact contents of a dumpster. As they pushed down with the forks, they dropped suddenly causing the machine to pivot. Their left forearm was pinched between the fire suppression guard on the front of the machine and the fire extinguisher guard on the rear. This resulted in a laceration which required ten sutures.
Powered haulage
No dys awy frm wrk,no rstr act
Accident narrative
Employee was standing in crosscut as a diesel scoop was pulling another diesel scoop. The chain hooked between the scoops pulled tight throwing a piece of rock striking the employee in the forehead above left eye. Employee received four sutures at the mine nurse and returned their next scheduled shift.
Short circuit protection; ratings and settings of circuit breakers.
30 CFR 75.601-1 · $151.00 proposed penalty
Handling of materials
Days away from work only
Accident narrative
Employee was opening a set of air lock doors when they felt their knee pop. Employee was seen by a doctor the same day and was taken off work beginning 7/22/25 as they were unable to perform their normal job.
Fall of roof or back
Accident only
Accident narrative
A fall of the roof occurred in the 1st SE Mains, #11 seam - 3rd 60 Beltline Crosscut 102 - #3 Entry - Spad 13+00. Fall measured approximately 25' length, 16'-18' width, 6'-10' height.
Non-Injury Accident Investigation
14.0 on-site hours reported
Violation — cited standard not reported
Clamping of trailing cables to equipment.
30 CFR 75.605 · $151.00 proposed penalty
Permanent splicing of trailing cables.
30 CFR 75.604(b) · Significant and substantial (S&S) · $336.00 proposed penalty
Power wires and cables; insulation and protection.
30 CFR 75.517 · $151.00 proposed penalty
Power wires and cables; insulation and protection.
30 CFR 75.517 · Significant and substantial (S&S) · $366.00 proposed penalty
Inspection of fire suppression devices.
30 CFR 75.1107-16-b · $151.00 proposed penalty
Inspection of fire suppression devices.
30 CFR 75.1107-16-b · $151.00 proposed penalty
Slip or fall of person
Days away from work only
Accident narrative
Employee was helping bolter move when the reel was engaged knocking EE to the ground, landing on EE's left wrist. Finished shift but had pain and swelling the following day. Diagnosed with a fracture of left wrist and taken off work beginning 7/16/25 as EE was unable to perform EE's normal duties.
Roof bolting.
30 CFR 75.204(c)(1) · $151.00 proposed penalty
Permanent splicing of trailing cables.
30 CFR 75.604(b) · Significant and substantial (S&S) · $755.00 proposed penalty
Ventilation controls.
30 CFR 75.333(d)(3) · $226.00 proposed penalty
Identification of circuit breakers.
30 CFR 75.904 · $151.00 proposed penalty
Criteria—Belt conveyors.
30 CFR 75.1403-5(g)
Permanent splicing of trailing cables.
30 CFR 75.604(b) · Significant and substantial (S&S) · $336.00 proposed penalty
Sources and definitions
MSHA Violations (issue date), Accidents (accident date) and Inspections (begin date).
Violation titles use current CFR headings to identify the cited rule; they are not the inspector’s account of what happened.
Counts describe published rows, including contractor records; accident records are not distinct incidents or numbers of people injured.
Zero means no matching records in the imported sources, not proof of no events. Historical coverage differs by source; absence before a source begins reporting is not a zero incident rate. Invalid or absent dates and records after the snapshot are excluded.
S&S means SIG_SUB=Y. Fatality records use DEGREE_INJURY_CD=01. Proposed penalties are not final assessed or paid amounts; missing dollar values are omitted.
Inspection hours are SUM_TOTAL_ON_SITE_HOURS attributed to the inspection start date, without supervisor/trainee hours. Missing hours are omitted; a started inspection may still be open.
Portfolio totals use current mine membership, including events before the current owner or operator's tenure.