Freeport-McMoRan Inc safety activity

Haul truck CAT82 was in the process of being loaded by Shovel 44 when, during the initial bucket load, a concealed boulder within the material struck the truck bed, resulting in a rough loading event.

While dismounting Dozer 01, the employee led with their left foot onto uneven ground. Upon contact, they experienced pain in the left distal quadriceps area.

Employee was shoveling carryback material from under a conveyor belt tail area and felt pain in lumbar spine.

When shovel dipper was coming out of the bed of the truck, a rock came out of the dipper and struck the dovetail, jarring the driver. Driver was taken to the ER and given time off, missing next shift, fully released on 11/03/2025.

Employee fell backwards and hit head on rock

Employee tripped on det cord injuring wrist and shoulder - became reportable 10/31/2025

Employee driving haul truck hit another haul truck

While disembarking a man van, a dayshift haul truck operator stepped into a low, rocky spot and rolled their ankle. The operator stated they felt immediate pain and sat down and asked for help.

Employee was adjusting lifting shackle and overhead crane hook during lifting operations. The employee's right index finger was pinched between lifting shackle and overhead crane hook. The employee suffered partial traumatic transphalangeal amputation of right index finger with nailbed involvement.

Operator slipped dismounting a motor grader, lost grip on the ladder and fell on the grader blade.

Contract employee was wearing rubber boots to work in a wet/muddy area for clean-up. They had some of the wet material go over the top of boots causing it to irritate the middle of the calves on both legs where the boots touched the skin. This rubbed the skin causing a burn in a circumference pattern around both legs.

While installing banjo bracket and arm on the shovel sticks, using a come along, the come along chain failed and the bracket and arm contacted the employee's right wrist area. EE was taken to the ER, diagnosed with a fracture and taken off work. CURRENTLY ONGOING

Employee was rough loaded in haul truck

Mill Maintenance Employee struck by chute liner at GL 3/4/5 chute.

A mechanic was working on a mast raise cylinder. Attempting to loosen a flange bolt with a wrench and it would not loosen. The mechanic then grabbed a 2lb hammer and struck the wrench several times. On the last strike they missed the wrench and struck their left hand in between the finger and the thumb

Employee was hit by 25lb bucket - became reportable 10/20/2025