Minntac Mine safety activity
MSHA violations, accident reports and inspections.
Safety activity
Slip or fall of person
No dys awy frm wrk,no rstr act
Accident narrative
The employee was installing reflectors into berms and adding orange tape. While stepping back, the employee tripped over a rock and fell, landing on their left elbow, which resulted in a laceration.
Verbal Hazard Complaint Inspections
3.0 on-site hours reported
Handtools (nonpowered)
No dys awy frm wrk,no rstr act
Accident narrative
2 MTMS were removing the outboard bearing on a dust collector. To free the bearing from the taper lock, the injured was using a 3lb. hammer while EE's partner held a chisel in a chisel holder against the bearing. During this process a piece of the chisel broke off and struck the injured resulting in a laceration to the left forearm.
Compliance Follow-up Inspection
0.5 on-site hours reported
Other
Days restricted activity only
Accident narrative
Employee was changing the 40-04-1 belt to an air tugger in step 2 Agglomerator. Employee was kneeling down while rigging up the 40 belt. Employee felt a pop in their right knee when they stood back up. EMS was contacted
Compliance Follow-up Inspection
1.3 on-site hours reported
Verbal Hazard Complaint Inspections
2.3 on-site hours reported
Housekeeping.
30 CFR 56.20003(b) · $11,450.00 proposed penalty
103 (g) Written Notification Hazard Complaint Inspectio
1.8 on-site hours reported
Powered haulage
Days restricted activity only
Accident narrative
At 8:30 pm the driver on a water truck was watering a road and hit rumble strips. The truck hit the strips and the employee was thrown forward and then pulled them back in the seat causing pain in the neck. EMS was called went to the ER for further eval. The truck was taken out of service so seatbelt could be checked and the road was graded. became recordable 6/10 with restrictions
Verbal Hazard Complaint Inspections
13.0 on-site hours reported
Verbal Hazard Complaint Inspections
0.8 on-site hours reported
Parking procedures for unattended equipment.
30 CFR 56.14207 · $151.00 proposed penalty
Flying or falling materials.
30 CFR 56.14110 · Significant and substantial (S&S) · $3,736.00 proposed penalty
Housekeeping.
30 CFR 56.20003(a) · $818.00 proposed penalty
Housekeeping.
30 CFR 56.20003(b) · $883.00 proposed penalty
103 (g) Written Notification Hazard Complaint Inspectio
4.3 on-site hours reported
Berms or guardrails.
30 CFR 56.9300(b) · $1,679.00 proposed penalty
Hoisting
Accident only
Accident narrative
A Crusher employee became entrapped in the Step 3 Fines Crusher elevator between the first and second floors. Our safety department became aware of the issue at 12:05 AM. The employee was originally trapped sometime after 11:30 PM on Saturday, April 19th. The employee was able to leave the elevator unharmed after the fire department responded and mechanically opened the doors
Protection for openings around travelways.
30 CFR 56.11012 · $504.00 proposed penalty
Protection of gas cylinder valves.
30 CFR 56.16006 · $504.00 proposed penalty
Correction of dangerous conditions.
30 CFR 56.12030 · $1,219.00 proposed penalty
Parking procedures for unattended equipment.
30 CFR 56.14207 · $465.00 proposed penalty
Safety defects; examination, correction and records.
30 CFR 56.14100(b) · $818.00 proposed penalty
Housekeeping.
30 CFR 56.20003(b) · Significant and substantial (S&S) · $4,383.00 proposed penalty
Sources and definitions
MSHA Violations (issue date), Accidents (accident date) and Inspections (begin date).
Violation titles use current CFR headings to identify the cited rule; they are not the inspector’s account of what happened.
Counts describe published rows, including contractor records; accident records are not distinct incidents or numbers of people injured.
Zero means no matching records in the imported sources, not proof of no events. Historical coverage differs by source; absence before a source begins reporting is not a zero incident rate. Invalid or absent dates and records after the snapshot are excluded.
S&S means SIG_SUB=Y. Fatality records use DEGREE_INJURY_CD=01. Proposed penalties are not final assessed or paid amounts; missing dollar values are omitted.
Inspection hours are SUM_TOTAL_ON_SITE_HOURS attributed to the inspection start date, without supervisor/trainee hours. Missing hours are omitted; a started inspection may still be open.
Portfolio totals use current mine membership, including events before the current owner or operator's tenure.