Jim Bridger Mine safety activity
MSHA violations, accident reports and inspections.
Safety activity
Spot Inspection
12.8 on-site hours reported
Slip or fall of person
Days away from work only
Accident narrative
Employee was climbing off the dozer that was located on the deck of the lowboy trailer while stepping backwards when they fell off the trailer approximately 3 to 4 feet to the ground onto their back. This resulted in pain to the right elbow, and the wind was knocked out of them. The employee was transported to a higher level of care for further evaluation.
Handling of materials
No dys awy frm wrk,no rstr act
Accident narrative
While positioning a barrel of solvent in the lube room of the 102. The employee's finger got caught between the barrel and the air compressor bank pinching the Left hand pinky finger crushing it between the barrel and the compressor bank.
Verbal Hazard Complaint Inspections
4.0 on-site hours reported
Slip or fall of person
Days away from work only
Accident narrative
An employee stopped for lunch break at the 2 high wall rock run. Employee climbed down the ladder grabbed both chock blocks, was walking to set one chock block on the left front wheel. The employee slipped on the ice and landed on their arm.
Spot Inspection
25.5 on-site hours reported
Sources and definitions
MSHA Violations (issue date), Accidents (accident date) and Inspections (begin date).
Violation titles use current CFR headings to identify the cited rule; they are not the inspector’s account of what happened.
Counts describe published rows, including contractor records; accident records are not distinct incidents or numbers of people injured.
Zero means no matching records in the imported sources, not proof of no events. Historical coverage differs by source; absence before a source begins reporting is not a zero incident rate. Invalid or absent dates and records after the snapshot are excluded.
S&S means SIG_SUB=Y. Fatality records use DEGREE_INJURY_CD=01. Proposed penalties are not final assessed or paid amounts; missing dollar values are omitted.
Inspection hours are SUM_TOTAL_ON_SITE_HOURS attributed to the inspection start date, without supervisor/trainee hours. Missing hours are omitted; a started inspection may still be open.
Portfolio totals use current mine membership, including events before the current owner or operator's tenure.