Eagle Materials Inc safety activity

Employee was clearing a blockage caused by a chunk of concrete when the tool being used to pry with slipped and caused the employee to catch EE's right ring finger between the tool and the framework.

Employee was operating a Stand behind skid steer under a stairway and catwalk area. the employee was backing out with a loaded bucket when it started to bog down and then jerked backwards quickly which caused EE's arm to be caught between the stair way structure and the equipment. this caused some scratches and bruising to the arm and a hairline fracture to the wrist.

Employee was using a pry bar to close a rail car door when it slipped out. The employee stumbled back and struck their shoulder against the vibrator causing possible rotator cuff impingement.

Employee was conducting electrical work from a manlift. Employee could not recall a specific event to cause the injury. They reported pain when inhaling deeply and upper back pain

The employee was tasked with cleaning out a chute connecting two elevated conveyors. During the process, a 4x8 rock fell of the top of the chute and struck the side of the employee's face. After completing the job, the employee requested medical attention due to their headache increasingly getting worse.

At approximately 6:00 pm employee and their partner were connecting steel, at the time of the incident there were strong gusts of wind. The beam was being pulled away by the wind while employee was holding it causing a strained shoulder.